Poster: A snowHead
|
helmet tonight Couldn't believe how dirty and smelly it had got. Did my gloves at the same time. The water was pretty disgusting looking. Just got to attack the bits of the helmet that can't be removed now with a brush. Deep joy.
|
|
|
|
|
Obviously A snowHead isn't a real person
Obviously A snowHead isn't a real person
|
Place in washing machine with salopettes & jacket.
Set 'hand wash' cycle.
Set 30 degrees.
Set 'extra rinses'.
Set 'no spin'.
Bio tab.
Press go.
Simples.
Last edited by Obviously A snowHead isn't a real person on Tue 8-03-11 21:55; edited 1 time in total
|
|
|
|
|
Well, the person's real but it's just a made up name, see?
Well, the person's real but it's just a made up name, see?
|
You should shower more often.
|
|
|
|
|
You need to Login to know who's really who.
You need to Login to know who's really who.
|
Does anyone know what might happen if I washed my boot liners ?
|
|
|
|
|
Anyway, snowHeads is much more fun if you do.
Anyway, snowHeads is much more fun if you do.
|
I bleached my gloves to kill the smell the other day but I went a bit strong and now have some tie die gloves.
Still I needed an excuse to buy some new ones.
|
|
|
|
|
You'll need to Register first of course.
You'll need to Register first of course.
|
moffatross, I hope that's for the gloves and not for the helmet. I've seen lots of warnings that helmets should never be put in the washing machine as it will seriously degrade the impact protection/absorbing properties. At the end of the day I guess it's your call, tis only your noggin you're protecting.
|
|
|
|
|
|
|
|
|
I am not going to comment on the possible degradation or otherwise of the helmet materials, but I think I'd be inclined to put the helmet inside some cushioning like actually tying it up inside a jacket washed at the same time as I would imagine there is a possibility for the surface to get cosmetically scratched and bumped which might be a shame as well as mentioned by moffatross, the possibility of the bumping damaging the drum of the machine!
|
|
|
|
|
You'll get to see more forums and be part of the best ski club on the net.
You'll get to see more forums and be part of the best ski club on the net.
|
Helmets don't routinely become submersed in water though do they? Won't doing that ruin the "impact foamy bits".
|
|
|
|
|
|
|
|
snowHeads are a friendly bunch.
snowHeads are a friendly bunch.
|
Megamum, I agree. In my experience, the salopettes & ski jacket make for adequate 'cushioning'.
DB, if I'm skiing hard, skiing in high humidity (falling rain or snow) or on a warm, sunny day, all of the materials, including the 'impact foamy bits' are bathed in moisture. But, pretending that doesn't happen and (using a scientific explantion), I'd really like to understand how those 'impact foamy bits' could be damaged by washing them.
blockhead, there's no science there. They're helmet salespeople.
|
|
|
|
|
And love to help out and answer questions and of course, read each other's snow reports.
And love to help out and answer questions and of course, read each other's snow reports.
|
I dont know how i got involved here i dont even wear a helmet
just trying to help i suppose
|
|
|
|
|
|
moffatross wrote: |
[b][i] routinely get significantly warmer than 30 degrees |
er, how? where?
|
|
|
|
|
You know it makes sense.
|
Dr John wrote: |
moffatross wrote: |
[b][i] routinely get significantly warmer than 30 degrees |
er, how? where? |
Blood temperature is around 37 degrees and the impact of sunshine on a helmet's surface (particularly a dark coloured one) will warm it to perhaps 60 or 70 degrees. Therefore the materials between head and helmet surface will warm to somewhere between the two.
|
|
|
|
|
Otherwise you'll just go on seeing the one name:
Otherwise you'll just go on seeing the one name:
|
Quote: |
You're obviously not a real doctor
|
No poo-poo sherlock.
What we have here, folks, is a complete mix up between moffatross and myself os whether we're talking in celcius or fahrenhiet.....
|
|
|
|
|
Poster: A snowHead
|
DB wrote: |
Helmets don't routinely become submersed in water though do they? Won't doing that ruin the "impact foamy bits". |
My Sweet ski helmet is exactly the same as my Sweet kayaking helmet, apart from a name change and a goggle clip. The kayaking lids been going strong for 6+ years so far, although the water I usually end up paddling in is significantly colder than 30 degrees lol.
|
|
|
|
|
Obviously A snowHead isn't a real person
Obviously A snowHead isn't a real person
|
I don't think the temp or water would do anything, the detergent might though.
|
|
|
|
|
Well, the person's real but it's just a made up name, see?
Well, the person's real but it's just a made up name, see?
|
It's the bouncing around in the washing machine that will do the damsge - if you drop a motorbike helmet you should throw it away and I see no reason why the lighter, weaker ski helmet should be any different.
|
|
|
|
|
You need to Login to know who's really who.
You need to Login to know who's really who.
|
The bouncing around would do far more damage to the helmet than a light detergent would...unless I suppose you were to keep it in said mild detergent every night for about a decade. It's not all that strong of an alkali...
And then it would depend on what the helmet was made out of.
Argh. I'm supposed to be doing a lab report and now I'm trying to find out what Giro helmets are made out of so I could work out how to get them to react. There's procrastination for you.
|
|
|
|
|
Anyway, snowHeads is much more fun if you do.
Anyway, snowHeads is much more fun if you do.
|
In my machine, on a short 'handwash cycle' and with salopettes, gloves & a ski jacket in there too, the machine is rammed enough that the helmet does no 'bouncing around' whatsoever. And I admit it. I have a weird fascination with watching washing machines doing their stuff.
|
|
|
|
|
You'll need to Register first of course.
You'll need to Register first of course.
|
moffatross, jobs a good un then
Apparently Giro helmets are made of polycarbonate. Looking at it, I doubt soap would do too much to it...
|
|
|
|
|
|
Quote: |
the impact of sunshine on a helmet's surface (particularly a dark coloured one) will warm it to perhaps 60 or 70 degrees.
|
Aye, right! No chance.
Lucky if it ever gets to 40°C, and frankly I'd be amazed at that.
|
|
|
|
|
|
|
|
You'll get to see more forums and be part of the best ski club on the net.
You'll get to see more forums and be part of the best ski club on the net.
|
moffatross, and anal helmet thread? I'm saying nowt.....
|
|
|
|
|
|
If you wear a buff or balaclava under your helmet they are far easier to wash - almost use them as a helmet liner- as well as stopping the bottoms of your ears and neck getting draughty you get to keep a clean helmet liner.
|
|
|
|
|
snowHeads are a friendly bunch.
snowHeads are a friendly bunch.
|
moffatross wrote: |
DB, if I'm skiing hard, skiing in high humidity (falling rain or snow) or on a warm, sunny day, all of the materials, including the 'impact foamy bits' are bathed in moisture. But, pretending that doesn't happen and (using a scientific explantion), I'd really like to understand how those 'impact foamy bits' could be damaged by washing them. |
Some things are splash proof, shower proof, water resitant, waterproof etc and some things are truly waterproof (can be immersed) - wasn't sure about the inside of a helmet.
Then again if helmets are truly waterproof won't wiping them with a cloth be enough as the dirt isn't ingrained?
|
|
|
|
|
And love to help out and answer questions and of course, read each other's snow reports.
And love to help out and answer questions and of course, read each other's snow reports.
|
moffatross,
Quote: |
In my machine, on a short 'handwash cycle' and with salopettes, gloves & a ski jacket in there too, the machine is rammed enough that the helmet does no 'bouncing around' whatsoever. And I admit it. I have a weird fascination with watching washing machines doing their stuff.
|
It's your head! I don't wear a helmet myself, but, if I did, I'd want to ensure my helmet was going to protect me properly - http://www.skiclub.co.uk/skiclub/news/story.aspx?storyID=8031
|
|
|
|
|
|
Why would a helmet left out in a temperature of, say, 24 degrees (C) be bound to heat up to over 40 degrees? And even in April there is the wind chill factor (unless you have a nice, sheltered seat).
|
|
|
|
|
You know it makes sense.
|
|
|
Otherwise you'll just go on seeing the one name:
Otherwise you'll just go on seeing the one name:
|
Quote: |
Why would a helmet left out in a temperature of, say, 24 degrees (C) be bound to heat up to over 40 degrees? And even in April there is the wind chill factor (unless you have a nice, sheltered seat). |
Ghost Dog, well it wouldn't up a mountain in Scotland would it, I mean it hasn't reached 24C even in midsummer in Moffat since 2006. But it's cooking in the Alps in April ... I couldn't lean my bare arms on the balcony 2 Easters ago, it was that hot.
|
|
|
|
|
Poster: A snowHead
|
If helmets got that hot you wouldn't be able to wear them or take them off with your bear hands. It was 24 degrees C in Selva first week in April last season, I guarantee my helmet could not be used to cook eggs on.
|
|
|
|
|
Obviously A snowHead isn't a real person
Obviously A snowHead isn't a real person
|
Colin B wrote: |
helmet tonight |
Have you got a Smeg washing machine ?
|
|
|
|
|
Well, the person's real but it's just a made up name, see?
Well, the person's real but it's just a made up name, see?
|
|
|
You need to Login to know who's really who.
You need to Login to know who's really who.
|
|
|
|