Poster: A snowHead
|
|
|
Obviously A snowHead isn't a real person
Obviously A snowHead isn't a real person
|
Furbag, what you are talking about is the DIN setting, which is a measure essentially of how much force is required to pop your ski off should you have a fall. The lower the setting, the lower the force required. Hence a beginner who should be falling down lots will have a low setting as it is safer for the skis to come off in a fall. When you hire equipment the fitter should be qualified to work out the appropriate setting for you. As far as I am aware (and no doubt someone else here will know more than me), only those qualified can set a DIN, if you play about with it yourself you could invalidate your insurance. If you are not happy, ie the skis are coming off too much or not at all, then take them back to be adjusted by a qualified technician. Hope that is reasonably helpful (just back from the pub!!)
By the way, lots of factors - height, ability and weight etc are taken into account when working out the DIN setting, hence the scales
|
|
|
|
|
Well, the person's real but it's just a made up name, see?
Well, the person's real but it's just a made up name, see?
|
|
|
You need to Login to know who's really who.
You need to Login to know who's really who.
|
|
|
Anyway, snowHeads is much more fun if you do.
Anyway, snowHeads is much more fun if you do.
|
|
|
You'll need to Register first of course.
You'll need to Register first of course.
|
Furbag wrote: |
I presume this tension also depends on ability as mjg mentions and me being say a beginer to inter. ( can link PARALLEL'S after a fashion ) this method you discribe would be about correct for my ability then.
If I was only just begining like my friend thats coming with me I presume they should be a lot easier to remove ??
I presume the further up the scale of skill you go the harder you want them to stay on your feet as you can push them harder then and get out of trouble ??
|
To some extent that is true, but it is really dependent on your style of skiing rather than your ability.
The point is that your legs can stand a higher strain for a very short time than they can for a longer time (where even "longer" is still only a small fraction of a second). So if most of your falls are likley to be happening at low speed, the bindings need to be set to release at a lower pressure because it will take too long for the pressure to reach the required level otherwise.
But the most important factors are your physical characteristics - boot sole length and weight particularly. Those will determine a "default" setting, and the techs shoudl only adjust away from that if you are noticably outside the average in terms of skiing style - which is mostly about how aggressive a skier you are.
Incidentally, for me, 5' 9", 28.0 boot size, 205lbs weight, average skier, I ski with a setting of 6.5. I have never had a pre-release, and never had a ski stay on when it shouldn't have at that setting.
|
|
|
|
|
|
|
|
|