Poster: A snowHead
|
Hi all,
Recently acquired Scarpa Quattro SL boots. Fit is generally good and they ski well. Only bummer is some shin bang. Towards the lateral side of the shins. I have never had shin bang before. Been in Dynafit Zzeros w/ Intuitions for the last 15 years.
I am not skiing backseat, not moving around in the boots or anything. It's just that my shins respectively the tissue next to it get some too concentrated pressure around the top centimeters of the boot shaft.
Boot flex is also a fair bit stiffer than what I am used to.
Any ideas how to remedy the bang?
Any experiences or concepts how to soften the initial flex of the boot?
Boosters are already installed and silicone pads are being worn.
Liner tongues did not seem to have molded any during the heat molding process. Redo the tongues with a heat gun?
thanks!
|
|
|
|
|
Obviously A snowHead isn't a real person
Obviously A snowHead isn't a real person
|
Did you gain or lose weight.
|
|
|
|
|
Well, the person's real but it's just a made up name, see?
Well, the person's real but it's just a made up name, see?
|
Gained a few kg in the last 1,5 yrs. From amateur cyclist lean to normal, 76->83 at 187cm height. Old boots behave just as last year, no issues.
|
|
|
|
|
You need to Login to know who's really who.
You need to Login to know who's really who.
|
Maybe loosen off the top buckles a bit and let the booster take the strain progressively?
I was going to suggest a booster as it cured shin bang on my old boots. I found I could run them looser without losing control.
Last edited by You need to Login to know who's really who. on Fri 3-11-23 8:41; edited 1 time in total
|
|
|
|
|
Anyway, snowHeads is much more fun if you do.
Anyway, snowHeads is much more fun if you do.
|
@danbre2022, normally shin issues like this are due to a few common things
1 what footbed is in the boot/ is it supporting your foot in a good functioning position
2 how is the your ankle joint range of motion, this can cause stress to the anterior muscles of your shin, so good flexibility and strengthening the anterior muscles might help
3 alignment of the leg, if the shaft of the leg isn't centered in the cuff of the boot it could be that twisting force, no cuff adjustment to make but you can use some foam padding to fill voids and trick the leg into being more centered
softening flex is not likely to do much as it is a specific point of pressure, possibly adding some material to make the boot taller and spread the pressure away from that point might help, but all guesses without seeing the foot and boot
|
|
|
|
|
You'll need to Register first of course.
You'll need to Register first of course.
|
hi CEM, thanks for your input!
1: custom footbed, foot is securely in place
2: ROM is fine. The bang is definitely from an actual pressure hot spot
3: I am already at 12mm of stiff foam..but this might still be it. Knees still track slight inwards, rotating the shins inward and thus exposing the lateral section of the shins to the pressure. Lack of cuff alignment is a pain in AT boots.
I am on the verge of giving up on this boot.
|
|
|
|
|
|
I still have dated but "newish" boots that function without trouble, so I am not hard pressed, fortunately.
|
|
|
|
|
|
Change in weight = change in leg-shape.
|
|
|
|
|
You'll get to see more forums and be part of the best ski club on the net.
You'll get to see more forums and be part of the best ski club on the net.
|
@danbre2022, who fitted them?
|
|
|
|
|
|